Genie error codes
Genie with Continental TME27 engine: engine controller codes
These are codes of the combustion engine controller (ECM), separate from the machine control codes. The code number is given in the manual's engine fault table. Below are 75 codes with the original message from the manufacturer's manual, and for 72 of them the description, causes and solution in the manual's own words. They apply to these machines: Genie S-80, S-85, S-80X, Z-80/60 with Continental engine. Source: Genie Service Manuals (Part No. 1269074, 1259369, 122985, 1268556, 88619), Continental engine code table.
- 16Sensors: Never Crank Synced at Start
- 107MAP: MAP Voltage Low
- 108MAP: MAP Pressure High
- 111IAT: IAT higher than expected 1
- 112IAT: IAT Voltage Low
- 113IAT: IAT Voltage High
- 116ECT/ CHT: ECT higher than expected 1
- 117ECT/ CHT: ECT Voltage Low
- 118ECT/ CHT: ECT Voltage High
- 121TPS: TPS1 < than TPS2
- 122TPS: TPS1 Low Voltage
- 123TPS: TPS1 High Voltage
- 127IAT: IAT higher than expected 2
- 129BP: BP Pressure Low
- 134EGO: EGO Open/Lazy Pre-cat
- 154Sensors: EGO Open/Lazy Post-cat
- 171Adaptive: AL High Gasoline Bank 1
- 172Learn: AL Low Gasoline Bank 1
- 217ECT/ CHT: ECT higher than expected 2
- 219Engine: Max Govern Speed Override
- 221TPS: TPS1 > than TPS2
- 222TPS: TPS2 Low Voltage
- 223TPS: TPS2 High Voltage
- 261Injectors: Injector Loop Open or Low-Side Short to Ground
- 262Injectors: Injector Coil Shorted
- 336Sensors: Crank Sync Noise
- 337Sensors: Crank Loss
- 341Sensors: Cam Sync Noise
- 342Cam Crank: Cam Loss
- 420Catalyst: Gasoline Cat Monitor
Showing the first 30: type more digits of the code.
The descriptions are quoted from the manufacturer's service documentation and are for guidance only. Clearing codes, calibrations and repairs are carried out by a qualified service technician according to the manual for the specific serial number. A machine with an active blocking code must not be used until the cause has been removed.