JLG error codes
JLG LE electric scissor lifts (3369LE, 4069LE, M3369, M4069)
The DTC code (3 to 5 digits) is shown by the JLG analyser in the top right corner of the screen, on machines with software P1.0 or later. Older software gives a two-digit flash code instead (e.g. 2/2) at the end of the help message. Below are 52 codes with the original message from the manufacturer's manual and its description. They apply to these machines: JLG 3369LE, 4069LE, M3369, M4069. Source: JLG Service and Maintenance Manual 3369LE / 4069LE / M3369 / M4069 (3121824), Flash Codes/DTC's table.
- 001EVERYTHING OK
- 002GROUND MODE OK
- 0022DIFFERENT FUNCTION SELECTED & IGNORED
- 0023FUNCTION SELECTED BUT TRIGGER SWITCH OPEN
- 0024JOYSTICK MOVED BUT NO FUNCTION SELECTED
- 0025ALARM SOUNDING - PLATFORM OVERLOADED
- 003ALARM SOUNDING - TILTED & ABOVE ELEVATION
- 004DRIVING AT CUTBACK - ABOVE ELEVATION
- 005DRIVE & LIFT UP PREVENTED - TILTED & ELEVATED
- 009DRIVE PREVENTED - ELEVATED ABOVE DRIVE CUTOUT HEIGHT
- 2112/1POWER CYCLE
- 2122/1KEYSWITCH FAULTY
- 2212/2FUNCTION PROBLEM - HORN PERMANENTLY SELECTED
- 22102/2TRIGGER CLOSED TOO LONG WHILE IN NEUTRAL
- 22342/2FUNCTION PROBLEM - DRIVE PERMANENTLY SELECTED
- 22352/2FUNCTION PROBLEM - LIFT PERMANENTLY SELECTED
- 22362/2FUNCTION PROBLEM - O/R PERMANENTLY SELECTED
- 22372/2JOYSTICK FAULTY - STEER SWITCHES ACTIVE TOGETHER
- 22382/2FUNCTIONS LOCKED OUT - SHORT TO PLATFORM ROW INPUT
- 22392/2FUNCTION PROBLEM - JOYSTICK CALIBRATION FAULTY
- 2242/2FUNCTION PROBLEM - STEER LEFT PERMANENTLY SELECTED
- 2252/2FUNCTION PROBLEM - STEER RIGHT PERMANENTLY SELECTED
- 2262/2ACCELERATOR (or JOYSTICK) FAULTY - WIPER OUT OF RANGE
- 2282/2FUNCTION LOCKED OUT - JOYSTICK NOT CENTERED
- 2292/2FUNCTION PROBLEM - TRIGGER PERMANENTLY CLOSED
- 2312/3FUNCTION PROBLEM - LIFT PERMANENTLY SELECTED
- 2512/5ELEV ANGLE SESOR FAULTY - VOLTAGE OUT OF RANGE
- 25122/5ELEV ANGLE SENSOR NOT DETECTING CHANGE
- 2522/5ELEV ANGLE SENSOR HAS NOT BEEN CALIBRATED
- 25352/5SHORT DETECTED ON IGNITION WIRING - CHECK HARNESS
Showing the first 30: type more digits of the code.
The descriptions are quoted from the manufacturer's service documentation and are for guidance only. Clearing codes, calibrations and repairs are carried out by a qualified service technician according to the manual for the specific serial number. A machine with an active blocking code must not be used until the cause has been removed.