Genie error codes
Genie Z-40/23N and Z-33/18: AC drive motor controller
These are codes of the AC electric motor controller, separate from the machine control codes; the number is given in the manual's table of motor controller faults. Below are 33 codes with the original message from the manufacturer's manual and its description. They apply to these machines: Genie Z-40/23N, Z-40/23N RJ, Z-33/18 DC. Source: Genie Service and Repair Manuals (Part No. 119817, 1268528, 1268514), AC motor controller code table.
- 6513Power MOS shorted
- 8785Hardware coil short time out
- 8977S TBY I HIGH
- 9233I=0 ever
- 12592Capacitor charge
- 12833Contactor driver
- 12835POS AUX Shorted
- 13912High temperature
- 16912High temperature
- 16913Thermic sensor time out
- 21776EEPROM warning
- 21808EEPROM time out
- 24592W atchdog
- 65280Tiller mismatch
- 65297Logic failure #3
- 65298Logic failure #2
- 65360Forward/Reverse
- 65503Safety feedback
- 65508Plat-Gnd switch open
- 65509Wrong zero
- 65510Output mismatch
- 65511Safety feedback
- 65512W rong set point
- 65513Wrong config.
- 65515Tiller errror
- 65516Current gain
- 65517Analog input
- 65520Hardware fault
- 65521Check up needed
- 65528Analog input
Showing the first 30: type more digits of the code.
The descriptions are quoted from the manufacturer's service documentation and are for guidance only. Clearing codes, calibrations and repairs are carried out by a qualified service technician according to the manual for the specific serial number. A machine with an active blocking code must not be used until the cause has been removed.