Genie Z-80/60, Z-135/70, S-100, S-105, S-120, S-125: faults by source and type
Genie message — BOOM ENVELOPE SAFETY — POSITION CHECK
This message occurs in machines: Genie SX-180, SX-150, SX-135 XC, SX-105 XC.
warning / function limited
The Genie display shows this message as “BOOM ENVELOPE SAFETY — POSITION CHECK”. It is a warning: some functions of the machine may be limited until the cause has been removed.
Effect on the machine: Disable Boom Down, Extend, and Ignition/Fuel. Boom Retract and Up allowed. All functions allowed once boom is lowered back into envelope. Alarm Sounds. Display message on LCD PRIMARY BOOM SAFETY ENVELOPE
Possible causes
The manual does not list the causes for this code: the service technician establishes them during diagnosis of the machine.
What you can do
Switch the machine off with the emergency stop and switch it on again. If the code comes back, do not use the machine and call service.
Solution from the manual
Return Boom back inside Operational Envelope
Source: Genie Service Manual Z-80/60 (88619), Service and Repair Manuals Z-135/70 (1268557) and S-100/S-105/S-120/S-125 (102916), Control System Fault Codes tables.
The descriptions are quoted from the manufacturer's service documentation and are for guidance only. Clearing codes, calibrations and repairs are carried out by a qualified service technician according to the manual for the specific serial number. A machine with an active blocking code must not be used until the cause has been removed.
Does the message not go away?
RK Rental services Genie lifts at our workshop or on site at the customer's premises (construction site, factory, warehouse). We read the code, remove the cause and select the parts by serial number.
Genie service · Genie parts · All Genie messages of this system