609 609 105609 609 104

Genie GR-20J and GR-26J (vertical mast lifts with jib)

Genie error code 01-62 — Controller interface board — Short-circuit on function switches

Message on the display: Controller interface board — Short-circuit on function switches

Code 01-62 occurs in machines: Genie GR-20J, GR-26J.

blocking fault

The function switch has been closed for more than 2.5 seconds.

Description from the Genie service manual, in the original wording.

Possible causes

The manual does not list the causes for this code: the service technician establishes them during diagnosis of the machine.

What you can do

Switch the machine off with the emergency stop and switch it on again. If the code comes back, do not use the machine and call service.

Solution from the manual

It should be possible to stop the alarm by stopping the main contactor or via the emergency stop. If the problem persists, check the wiring connection. If there is no problem, the alarm is due to an internal fault.

Source: Genie Service and Repair Manual GR-20J / GR-26J (Part No. 227656, 1312899), Fault Codes section.

The descriptions are quoted from the manufacturer's service documentation and are for guidance only. Clearing codes, calibrations and repairs are carried out by a qualified service technician according to the manual for the specific serial number. A machine with an active blocking code must not be used until the cause has been removed.

Does code 01-62 not go away?

RK Rental services Genie lifts at our workshop or on site at the customer's premises (construction site, factory, warehouse). We read the code, remove the cause and select the parts by serial number.

Book a service

Genie service · Genie parts · All Genie codes of this system

Neighbouring Genie codes