Genie error codes
Older Genie GS scissor lifts with LED display (GS-1530, GS-1930, GS-2032, GS-2632, GS-3232, GS-2046, GS-2646, GS-3246)
The two-character code (e.g. 02, 18, 58, LL, OL) is shown on the LED diagnostic display of the controller (ECM). When a fault code is displayed, a dot lights up next to the digits. This is an older generation than the SmartLink control with letter + 3-digit codes. Below are 35 codes with the original message from the manufacturer's manual and its description. They apply to these machines: Genie GS-1530, GS-1532, GS-1930, GS-1932, GS-2032, GS-2632, GS-3232, GS-2046, GS-2646, GS-3246 built before the SmartLink control (manuals 72972 and 97385). Source: Genie Service Manual GS-30/32/46 (Part No. 97385) and GS-2046/2646/3246 (Part No. 72972), Fault Codes section.
- 01Internal ECM error.
- 02ECM/Platform communication error.
- 03Undefined platform DIP switch settings.
- 12Chassis up/down toggle closed at start up.
- 18Pothole guard failure.
- 19Limit switch failure.
- 42Platform left turn switch fault.
- 43Platform right turn switch fault.
- 46Platform drive enable switch fault.
- 47Platform joystick fault.
- 52Forward coil fault.
- 53Reverse coil fault.
- 54Up coil fault. (Not used on GS-3232)
- 55Down coil fault.
- 56Steer right coil fault.
- 57Steer left coil fault.
- 58Brake coil fault.
- 59Series/parallel coil fault.
- 68Low battery voltage.
- LLOff level fault.
- OLOverload cutout fault.
- 88ECM has been erased.
- 00CPU error.
- 10CPU error.
- 11CPU error.
- 14CPU error.
- 15CPU error.
- 16CPU error.
- 17CPU error.
- 33Function enable sw itch is tied dow n.
Showing the first 30: type more digits of the code.
The descriptions are quoted from the manufacturer's service documentation and are for guidance only. Clearing codes, calibrations and repairs are carried out by a qualified service technician according to the manual for the specific serial number. A machine with an active blocking code must not be used until the cause has been removed.