Genie GS scissor lifts with SmartLink control (GS-1930, GS-1932, GS-2632, GS-3246, GS-4047, GS-4655)
Genie error code F063 — SENSORFAULT STEER ANG:RANGE
Message on the display: SENSORFAULT STEER ANG:RANGE
Code F063 occurs in machines: Genie GS-2669 BE, GS-3369 BE, GS-4069 BE, GS-2669 DC, GS-3369 DC, GS-4069 DC.
warning / function limited
Steer angle sensor out of range.
Description from the Genie service manual, in the original wording.
Effect on the machine: Drive performance reduced.
Possible causes
- Short or open circuit of the steer angle sensor.
- Short or open circuit of the steer angle sensor harness.
- Steer angle sensor needs to be calibrated.
- Faulty steer angle sensor.
- Right rear DCON ECM.
What you can do
Switch the machine off with the emergency stop and switch it on again. If the code comes back, do not use the machine and call service.
What service does
A qualified service technician reads the code with the manufacturer's diagnostic tools, finds the cause, clears the code and carries out a function test.
Source: Genie Service and Repair Manual GS-30/32/46/47 (Part No. 1272217GT), Fault Codes section.
The descriptions are quoted from the manufacturer's service documentation and are for guidance only. Clearing codes, calibrations and repairs are carried out by a qualified service technician according to the manual for the specific serial number. A machine with an active blocking code must not be used until the cause has been removed.
Does code F063 not go away?
RK Rental services Genie lifts at our workshop or on site at the customer's premises (construction site, factory, warehouse). We read the code, remove the cause and select the parts by serial number.
Genie service · Genie parts · All Genie codes of this system