Older Genie S-100, S-105, S-120, S-125: display messages
Genie message — DRIVE VALVE NOT CALIBRATED
This message occurs in machines: Genie S-100, S-105, S-120, S-125.
warning / function limited
The Genie display shows this message as “DRIVE VALVE NOT CALIBRATED”. It is a warning: some functions of the machine may be limited until the cause has been removed.
Effect on the machine: No movement on Drive forward or reverse functions until joystick is moved past half stroke.
Possible causes
- Reset propel valve defaults set from display. Refer to Display module section.
What you can do
Switch the machine off with the emergency stop and switch it on again. If the code comes back, do not use the machine and call service.
Solution from the manual
Calibrate propel thresholds refer to repair section.
Source: Genie Service Manual S-100 / S-105 / S-120 / S-125 (Part No. 62401), Fault Codes section.
The descriptions are quoted from the manufacturer's service documentation and are for guidance only. Clearing codes, calibrations and repairs are carried out by a qualified service technician according to the manual for the specific serial number. A machine with an active blocking code must not be used until the cause has been removed.
Does the message not go away?
RK Rental services Genie lifts at our workshop or on site at the customer's premises (construction site, factory, warehouse). We read the code, remove the cause and select the parts by serial number.
Genie service · Genie parts · All Genie messages of this system