Zoomlion error codes

Zoomlion ZS1218ERT electric rough terrain scissor lift

The code is shown on the diagnostic display of the platform control box and on the display of the ground control box. The fault must be removed before work resumes. Below are 51 codes with the original message from the manufacturer's manual and its description. They apply to these machines: Zoomlion ZS1218ERT. Source: Zoomlion Service and Maintenance Manual (global.zoomlion-access.com), ZS1218ERT, fault code table.

The descriptions are quoted from the manufacturer's service documentation and are for guidance only. Clearing codes, calibrations and repairs are carried out by a qualified service technician according to the manual for the specific serial number. A machine with an active blocking code must not be used until the cause has been removed.

All Zoomlion codes: the list

Code	Meaning	Type
01	System fault	blocking fault
02	Communication Fault	blocking fault
04	Calibration Fault	blocking fault
09	GPS communication Fault	warning / function limited
12	Chassis Up or Down Switch ON	blocking fault
19	Foot Pedal Fault	blocking fault
20	BMS Comm Fault	blocking fault
21	BMS Level1 Fault	warning / function limited
22	BMS Level2 Fault	blocking fault
23	BMS Level3 Fault	blocking fault
24	Ultrasound Sensor Fault	blocking fault
25	Anti-Collision Fault	blocking fault
31	Pressure Sensor1 Fault	blocking fault
32	Angle Sensor Fault	blocking fault
33	Anti-Collision Switch Fault	blocking fault
35	Pressure Sensor 2 Fault	blocking fault
36	Battery Drain Alarm	blocking fault
37	ECU Sleep	message
38	Tilt Angle Over Limit Disable Leg Function	blocking fault
39	Limit Switch Fault	blocking fault
40	Down Limit Check Fault	blocking fault
41	Front Bridge Tilt	blocking fault
42	Platform Left Button ON	blocking fault
43	Platform Right Button ON	blocking fault
44	Open Leg Failure	blocking fault
45	RB Leg Coil Fault	blocking fault
46	Platform Enable Button ON	blocking fault
47	Joystick Not In Netural	blocking fault
48	Horn Coil Fault	blocking fault
49	Select Main Coil Fault	blocking fault
54	Lift Up Coil Fault	blocking fault
55	Lift Down Coil 1 Fault	blocking fault
56	Right Turn Coil Fault	blocking fault
57	Left Turn Coil Fault	blocking fault
68	Battery low voltage fault	blocking fault
75	Pump Motor Controller Fault	warning / function limited
76	Left Motor Controller Fault	blocking fault
77	Right Motor Controller Fault	blocking fault
80	Platform Load is over 80%	warning / function limited
88	Motor Driver Comm Fault	blocking fault
89	Tilt Angle Over Limit	warning / function limited
90	Platform Load is over 90%	warning / function limited
93	Lift Down Coil 2 Fault	blocking fault
94	LEG Stretch Coil Fault	blocking fault
95	LEG Anastole Coil Fault	blocking fault
96	LF Leg Coil Fault	blocking fault
97	LB Leg Coil Fault	blocking fault
98	RF Leg Coil Fault	blocking fault
99	Platform Load is over 99%	warning / function limited
OL	Overloaded Platform Fault	blocking fault
LL	Machine Inclined	blocking fault