Genie S-85 XC FE/E, S-60 DC, Z-60 DC: drive motor controllers
Genie error code 0x2542 — PDO Mapping Error
Message on the display: PDO Mapping Error
Code 0x2542 occurs in machines: Genie S-85 XC FE, S-85 XC E, Z-60 DC, S-60 DC.
blocking fault
Flash pattern 8-2 (flash code 0x82).
Description from the Genie service manual, in the original wording.
Effect on the machine: PDO message disabled. Fault Action: None, unless a fault action is programmed in VCL.
Possible causes
- The PDO Map has too many data bytes assigned or has objects mapped that are not compatible. Adjust PDO Settings. See Programmer » Application Setup » CAN Interface » PDO Setups.
What you can do
Switch the machine off with the emergency stop and switch it on again. If the code comes back, do not use the machine and call service.
Solution from the manual
Set: Incorrect PDO map detected. Clear: Reset Controller.
Source: Genie Service and Repair Manuals (Part No. 1337498, 1307785, 1299608), drive controller code table.
The descriptions are quoted from the manufacturer's service documentation and are for guidance only. Clearing codes, calibrations and repairs are carried out by a qualified service technician according to the manual for the specific serial number. A machine with an active blocking code must not be used until the cause has been removed.
Does code 0x2542 not go away?
RK Rental services Genie lifts at our workshop or on site at the customer's premises (construction site, factory, warehouse). We read the code, remove the cause and select the parts by serial number.
Genie service · Genie parts · All Genie codes of this system