Genie Z-80/60, Z-135/70, S-100, S-105, S-120, S-125: faults by source and type
Genie message — LSB2RS (101FT)/LSB4ES (100 FT) CROSS-CHECK — FAULT CHECK
This message occurs in machines: Genie SX-105 XC.
blocking fault
The Genie display shows this message as “LSB2RS (101FT)/LSB4ES (100 FT) CROSS-CHECK — FAULT CHECK”. It is a blocking fault or a safety-related code: do not use the machine until the cause has been found and removed.
Effect on the machine: Disable Boom Up, Extend, Down, TT Rotate, and Propel powers in SCON. Boom Retract allowed and Boom Down allowed if fully retracted as sensed by LSB3RO. Alarm sounds. Display message on LCD: LSB2RS/LSB4ES CROSS CHECK FAULT.
Possible causes
The manual does not list the causes for this code: the service technician establishes them during diagnosis of the machine.
What you can do
Switch the machine off with the emergency stop and switch it on again. If the code comes back, do not use the machine and call service.
Solution from the manual
Power up controller with problem corrected.
Source: Genie Service Manual Z-80/60 (88619), Service and Repair Manuals Z-135/70 (1268557) and S-100/S-105/S-120/S-125 (102916), Control System Fault Codes tables.
The descriptions are quoted from the manufacturer's service documentation and are for guidance only. Clearing codes, calibrations and repairs are carried out by a qualified service technician according to the manual for the specific serial number. A machine with an active blocking code must not be used until the cause has been removed.
Does the message not go away?
RK Rental services Genie lifts at our workshop or on site at the customer's premises (construction site, factory, warehouse). We read the code, remove the cause and select the parts by serial number.
Genie service · Genie parts · All Genie messages of this system
Neighbouring Genie messages
- LSB3RO (RETRACTED)/LSB4EO (EXTENDED) CROSS-CHECK — FAULT CHECK
- LSJ1RS/LSJ1RO CROSS- CHECK — FAULT CHECK
- LSB2RO (101FT)/LSB4EO (100 FT) CROSS-CHECK — FAULT CHECK
- PLATFORM ROTATE JOYSTICK — VALUE AT 5.0 V VALUE TOO HIGH VALUE TOO LOW VALUE AT 0 V
- PLATFORM LOAD CELL OVERLOADED — NOT CALIBRATED INTERNAL LOAD CELL STATUS INVALID SETUP CROSS CHECK FAULT
- OVERLOAD RECOVERY — FAULT