Genie Z-80/60, Z-135/70, S-100, S-105, S-120, S-125: faults by source and type
Genie message — PLATFORM LOAD CELL OVERLOADED — NOT CALIBRATED INTERNAL LOAD CELL STATUS INVALID SETUP CROSS CHECK FAULT
This message occurs in machines: Genie ZX-135/70.
blocking fault
The Genie display shows this message as “PLATFORM LOAD CELL OVERLOADED — NOT CALIBRATED INTERNAL LOAD CELL STATUS INVALID SETUP CROSS CHECK FAULT”. It is a blocking fault or a safety-related code: do not use the machine until the cause has been found and removed.
Effect on the machine: Zero load not calibrated: Alarm sounds indicating a fault. Overload LED is on. Functions disabled, engine shutdown Auxiliary functions enabled except extend. Zero load calibrated, gain is not: Unit operates with reduced load capacity. Alarm sounds indicating a fault. Overload LED is on. Functions disabled, engine shutdown. Auxiliary functions enabled except extend.
Possible causes
The manual does not list the causes for this code: the service technician establishes them during diagnosis of the machine.
What you can do
Switch the machine off with the emergency stop and switch it on again. If the code comes back, do not use the machine and call service.
Solution from the manual
Calibrate the load cell. Inspect load cell for damage. Cycle power off then back on. If fault persist, replace load cell. Calibrate load cell with proper. load or replace Inspect load cell for damage. Cycle power off then back on. If fault persist, replace load cell.
Source: Genie Service Manual Z-80/60 (88619), Service and Repair Manuals Z-135/70 (1268557) and S-100/S-105/S-120/S-125 (102916), Control System Fault Codes tables.
The descriptions are quoted from the manufacturer's service documentation and are for guidance only. Clearing codes, calibrations and repairs are carried out by a qualified service technician according to the manual for the specific serial number. A machine with an active blocking code must not be used until the cause has been removed.
Does the message not go away?
RK Rental services Genie lifts at our workshop or on site at the customer's premises (construction site, factory, warehouse). We read the code, remove the cause and select the parts by serial number.
Genie service · Genie parts · All Genie messages of this system