Genie Z-80/60, Z-135/70, S-100, S-105, S-120, S-125: faults by source and type
Genie message — SAFETY SECONDARY BOOM ANGLE SENSOR — OUT OF TOLERANCE
This message occurs in machines: Genie Z-135/70.
blocking fault
The Genie display shows this message as “SAFETY SECONDARY BOOM ANGLE SENSOR — OUT OF TOLERANCE”. It is a blocking fault or a safety-related code: do not use the machine until the cause has been found and removed.
Effect on the machine: Primary up, Secondary up/down and Extend disabled, Alarm sounds
Possible causes
The manual does not list the causes for this code: the service technician establishes them during diagnosis of the machine.
What you can do
Switch the machine off with the emergency stop and switch it on again. If the code comes back, do not use the machine and call service.
Solution from the manual
Recalibrate sensor
Source: Genie Service Manual Z-80/60 (88619), Service and Repair Manuals Z-135/70 (1268557) and S-100/S-105/S-120/S-125 (102916), Control System Fault Codes tables.
The descriptions are quoted from the manufacturer's service documentation and are for guidance only. Clearing codes, calibrations and repairs are carried out by a qualified service technician according to the manual for the specific serial number. A machine with an active blocking code must not be used until the cause has been removed.
Does the message not go away?
RK Rental services Genie lifts at our workshop or on site at the customer's premises (construction site, factory, warehouse). We read the code, remove the cause and select the parts by serial number.
Genie service · Genie parts · All Genie messages of this system
Neighbouring Genie messages
- SAFETY SECONDARY BOOM ANGLE SENSOR — VALUE TOO HIGH
- SAFETY SECONDARY BOOM ANGLE SENSOR — VALUE TOO LOW
- SAFETY SECONDARY BOOM ANGLE SENSOR — VALUE AT 0 V
- SAFETY SECONDARY BOOM ANGLE SENSOR — NOT CALIBRATED
- SAFETY SECONDARY BOOM ANGLE SENSOR — JUST CALIBRATED
- OPERATIONAL TURNTABLE LEVEL SENSOR X DIRECTION — VALUE AT 5.0 V