Genie with Deutz D436 engine: engine controller codes
Genie error code 174-0 — Fuel temperature warning: exceeded level
Message on the display: Fuel temperature warning: exceeded level
Code 174-0 occurs in machines: Genie S-60 XC, S-60.
warning / function limited
SPN 174, FMI 0.
Description from the Genie service manual, in the original wording.
Possible causes
The manual does not list the causes for this code: the service technician establishes them during diagnosis of the machine.
What you can do
Switch the machine off with the emergency stop and switch it on again. If the code comes back, do not use the machine and call service.
What service does
A qualified service technician reads the code with the manufacturer's diagnostic tools, finds the cause, clears the code and carries out a function test.
Source: Genie Service and Repair Manual S-60 XC, Deutz engine code table.
The descriptions are quoted from the manufacturer's service documentation and are for guidance only. Clearing codes, calibrations and repairs are carried out by a qualified service technician according to the manual for the specific serial number. A machine with an active blocking code must not be used until the cause has been removed.
Does code 174-0 not go away?
RK Rental services Genie lifts at our workshop or on site at the customer's premises (construction site, factory, warehouse). We read the code, remove the cause and select the parts by serial number.
Genie service · Genie parts · All Genie codes of this system
Neighbouring Genie codes
- 110-2Coolant temp: short circuit; harness
- 111-1Coolant level warning: switch input "Low coolant level" is active
- 171-12Internal temperature: Control unit internal temperature out of range.
- 174-2Fuel temp: short circuit; harness Functional fault warning
- 190-0Excess speed switch-off: speed i excess of limit Sensors
- 190-8Speed sensor 1: sensor fault; distance from gear; harness / Speed sensor 2: sensor fault; distance from gear; harness