Genie S-40 XC
Genie error code 1-13 — Engine Can Bus — Not detected
Message on the display: Engine Can Bus — Not detected
Code 1-13 occurs in machines: Genie S-40 XC.
blocking fault
The Genie display shows code 1-13 with the message “Engine Can Bus — Not detected”. It is a blocking fault or a safety-related code: do not use the machine until the cause has been found and removed.
Effect on the machine: Disable engine start for tier 4F engines.
Possible causes
- Engine CANBUS CAN+ or CAN- shorted to supply.
What you can do
Switch the machine off with the emergency stop and switch it on again. If the code comes back, do not use the machine and call service.
Solution from the manual
* Verify with a voltmeter that CAN+ and CAN- lines are not shorted.* Measure the resistance between D228CAN+ (YL, TCON J9-3) and D228CAN- (GR, TCON J9-4); should be between 55 and 65 ohms. * D228CAN+ (YL, TCON J9-3) should be between 1V and 5V. * D228CAN- (GR, TCON J9-4) should be between 1V and 5V. Remove short(s) and cycle power.
Source: Genie Service and Repair Manual S-40 XC (Part No. 1322629, 1286829GT), Fault Codes section.
The descriptions are quoted from the manufacturer's service documentation and are for guidance only. Clearing codes, calibrations and repairs are carried out by a qualified service technician according to the manual for the specific serial number. A machine with an active blocking code must not be used until the cause has been removed.
Does code 1-13 not go away?
RK Rental services Genie lifts at our workshop or on site at the customer's premises (construction site, factory, warehouse). We read the code, remove the cause and select the parts by serial number.
Genie service · Genie parts · All Genie codes of this system