Genie S-40 XC
Genie error code 241-9 — Turntable Sensor Power — P109PWR is shorted to B-
Message on the display: Turntable Sensor Power — P109PWR is shorted to B-
Code 241-9 occurs in machines: Genie S-40 XC.
blocking fault
The Genie display shows code 241-9 with the message “Turntable Sensor Power — P109PWR is shorted to B-”. It is a blocking fault or a safety-related code: do not use the machine until the cause has been found and removed.
Effect on the machine: Boom Up and Extend inhibited.
Possible causes
- P109PWR Short to B-.
What you can do
Switch the machine off with the emergency stop and switch it on again. If the code comes back, do not use the machine and call service.
Solution from the manual
* Cycle power to allow the machine to re- test the fault.
Source: Genie Service and Repair Manual S-40 XC (Part No. 1322629, 1286829GT), Fault Codes section.
The descriptions are quoted from the manufacturer's service documentation and are for guidance only. Clearing codes, calibrations and repairs are carried out by a qualified service technician according to the manual for the specific serial number. A machine with an active blocking code must not be used until the cause has been removed.
Does code 241-9 not go away?
RK Rental services Genie lifts at our workshop or on site at the customer's premises (construction site, factory, warehouse). We read the code, remove the cause and select the parts by serial number.
Genie service · Genie parts · All Genie codes of this system
Neighbouring Genie codes
- 206-13TCON / PCON — TCON Bank Power Not Detected PCON Bank Power Not Detected
- 240-9Turntable Sensor Power — P85PWR Short to B-
- 240-11Turntable Sensor Power — P85PWR Short to B+
- 241-11Turntable Sensor Power — P109PWR is shorted to B+
- 263-9Platform Level Loop Coil — Shorted to GND
- 263-11Platform Level Loop Coil — Shorted to supply voltage