Genie S-85 XC FE and S-85 XC E (hybrid and electric drive)
Genie error code 94-13 — Primary boom length — Not detected
Message on the display: Primary boom length — Not detected
Code 94-13 occurs in machines: Genie S-85 XC FE, S-85 XC E.
blocking fault
The Genie display shows code 94-13 with the message “Primary boom length — Not detected”. It is a blocking fault or a safety-related code: do not use the machine until the cause has been found and removed.
Effect on the machine: Machine limited to recovery functions Disabled functions out of stowed: * Boom extend / up * Turntable rotate
Possible causes
- No CAN communication
What you can do
Switch the machine off with the emergency stop and switch it on again. If the code comes back, do not use the machine and call service.
Solution from the manual
* 26V from TCON pin J2-9 to length sensor pin 1 (P198PWR RD). * B- at angle sensor pin 2. * 60Ω across length sensor pins 3 and 4 with power off.
Source: Genie Service and Repair Manual S-85 XC FE / E (Part No. 1337498), Fault Codes section.
The descriptions are quoted from the manufacturer's service documentation and are for guidance only. Clearing codes, calibrations and repairs are carried out by a qualified service technician according to the manual for the specific serial number. A machine with an active blocking code must not be used until the cause has been removed.
Does code 94-13 not go away?
RK Rental services Genie lifts at our workshop or on site at the customer's premises (construction site, factory, warehouse). We read the code, remove the cause and select the parts by serial number.
Genie service · Genie parts · All Genie codes of this system