JLG ES series scissor lifts (1930ES, 2030ES, 2630ES, 2646ES, 3246ES)
JLG error code 8216 — LSS ANGLE SENSOR HAS NOT BEEN CALIBRATED
Message on the display: LSS ANGLE SENSOR HAS NOT BEEN CALIBRATED
Code 8216 occurs in machines: JLG 1932RS, 6RS, 3248RS, 10RS.
blocking fault
The Angle Sensor has never been calibrated and the control system assumes that the platform is overloaded.
Description from the JLG service manual, in the original wording.
Possible causes
The manual does not list the causes for this code: the service technician establishes them during diagnosis of the machine.
What you can do
Switch the machine off with the emergency stop and switch it on again. If the code comes back, do not use the machine and call service.
Solution from the manual
Calibrate the Angle Sensor using the CALIBRATION: ANGLE submenu to clear the message.; HEALTH (Status LED) - ON
Source: JLG Service and Maintenance Manual, ES series (Diagnostic Trouble Codes section).
The descriptions are quoted from the manufacturer's service documentation and are for guidance only. Clearing codes, calibrations and repairs are carried out by a qualified service technician according to the manual for the specific serial number. A machine with an active blocking code must not be used until the cause has been removed.
Does code 8216 not go away?
RK Rental services JLG lifts at our workshop or on site at the customer's premises (construction site, factory, warehouse). We read the code, remove the cause and select the parts by serial number.