Genie S-85 XC FE/E, S-60 DC, Z-60 DC: drive motor controllers
Genie error code 0x2106 — Analog 31 Out of Range / Pin 26
Message on the display: Analog 31 Out of Range / Pin 26
Code 0x2106 occurs in machines: Genie S-85 XC FE, S-85 XC E, Z-60 DC, S-60 DC.
blocking fault
Flash pattern 12-7 (flash code 0xC7).
Description from the Genie service manual, in the original wording.
Effect on the machine: See Analog 1 Out of Range.
Possible causes
- See Analog 1 Out of Range.
What you can do
Switch the machine off with the emergency stop and switch it on again. If the code comes back, do not use the machine and call service.
What service does
A qualified service technician reads the code with the manufacturer's diagnostic tools, finds the cause, clears the code and carries out a function test.
Source: Genie Service and Repair Manuals (Part No. 1337498, 1307785, 1299608), drive controller code table.
The descriptions are quoted from the manufacturer's service documentation and are for guidance only. Clearing codes, calibrations and repairs are carried out by a qualified service technician according to the manual for the specific serial number. A machine with an active blocking code must not be used until the cause has been removed.
Does code 0x2106 not go away?
RK Rental services Genie lifts at our workshop or on site at the customer's premises (construction site, factory, warehouse). We read the code, remove the cause and select the parts by serial number.
Genie service · Genie parts · All Genie codes of this system
Neighbouring Genie codes
- 0x262CSee Analog 19 Out of Range
- 0x2834Pump Current Sensor Fault Sensor zero- current offset close to supply voltage or sensor (supply) ground.
- 0x2860Branding Error
- 0x2108VCL Watchdog The time interval of the VCL watchdog (WD#) exceeded the timeout value.
- 0x2111Autobaud Failure on linked controller CAN port
- 0x2113Primary State Error