Genie S-85 XC FE/E, S-60 DC, Z-60 DC: drive motor controllers
Genie error code 0x2169 — Coil Supply Fault Fault Type(s):
Message on the display: Coil Supply Fault Fault Type(s):
Code 0x2169 occurs in machines: Genie S-85 XC FE, S-85 XC E, Z-60 DC, S-60 DC.
blocking fault
Flash pattern 10-9 (flash code 0xA9). Sub-types: 1 = short to B- or HW fault. 2 = Coil Supply disabled due to shorted (internal) driver.* 3 = Coil Supply startup enable check failed. 4 = Coil Supply startup disable check failed. *a short must first be detected.
Description from the Genie service manual, in the original wording.
Effect on the machine: ShutdownAll: ShutdownMotor ShutdownMainContactor ShutdownEMrake ShutdownThrottle ShutdownInterlock ShutdownDriver1 to 7 ShutdownPD FullBrake ShutdownPump ShutdownCoilSupply ShutdownVehicle ShutdownLower ShutdownLift
Possible causes
- Short on driver loads.
- Dirty connector pins at controller or device.
- Bad connector crimps or faulty wiring.
- Controller is defective.
What you can do
Switch the machine off with the emergency stop and switch it on again. If the code comes back, do not use the machine and call service.
Solution from the manual
Set: Short detected after the startup check has passed. A low side driver short is detected and the respective fault action fails to cut-off driver current. Coil supply startup test fails. Clear: Reset Controller.
Source: Genie Service and Repair Manuals (Part No. 1337498, 1307785, 1299608), drive controller code table.
The descriptions are quoted from the manufacturer's service documentation and are for guidance only. Clearing codes, calibrations and repairs are carried out by a qualified service technician according to the manual for the specific serial number. A machine with an active blocking code must not be used until the cause has been removed.
Does code 0x2169 not go away?
RK Rental services Genie lifts at our workshop or on site at the customer's premises (construction site, factory, warehouse). We read the code, remove the cause and select the parts by serial number.
Genie service · Genie parts · All Genie codes of this system
Neighbouring Genie codes
- 0x2165Driver 6 Fault Fault Type(s): See Driver 1 Fault
- 0x2166Driver 7 Fault Fault Type(s): See Driver 1 Fault
- 0x2632Driver Assignment Fault Type(s): 5 {X} = Driver number that cause the fault.
- 0x2620Analog 1/ Pin 16 Out of Range Fault Type(s):
- 0x2621See Analog 2 / Pin 8 Out of Range
- 0x2622See Analog 3 / Pin 31 Out of Range