609 609 105609 609 104

Genie S-85 XC FE/E, S-60 DC, Z-60 DC: drive motor controllers

Genie error code 0x2631 — Analog Assignment Fault Fault Type(s): 13 X = Analog Input number that caused the fault. {X = 1-9, 14, 18- 19, 31}

Message on the display: Analog Assignment Fault Fault Type(s): 13 X = Analog Input number that caused the fault. {X = 1-9, 14, 18- 19, 31}

Code 0x2631 occurs in machines: Genie S-85 XC FE, S-85 XC E, Z-60 DC, S-60 DC.

warning / function limited

Flash pattern 11-12 (flash code 0xBC).

Description from the Genie service manual, in the original wording.

Effect on the machine: None (warning)

Possible causes

  • An Analog Input is used for two or more functions.
  • An Analog Input is outside the range of analog inputs. See Programmer » Controller Setup » IO Assignments » Controls.

What you can do

Switch the machine off with the emergency stop and switch it on again. If the code comes back, do not use the machine and call service.

Solution from the manual

Clear: Resolve assignment conflict, and then Reset Controller.

Source: Genie Service and Repair Manuals (Part No. 1337498, 1307785, 1299608), drive controller code table.

The descriptions are quoted from the manufacturer's service documentation and are for guidance only. Clearing codes, calibrations and repairs are carried out by a qualified service technician according to the manual for the specific serial number. A machine with an active blocking code must not be used until the cause has been removed.

Does code 0x2631 not go away?

RK Rental services Genie lifts at our workshop or on site at the customer's premises (construction site, factory, warehouse). We read the code, remove the cause and select the parts by serial number.

Book a service

Genie service · Genie parts · All Genie codes of this system

Neighbouring Genie codes