Genie S-40 XC
Genie error code 95-13 — Engine RPM — Not detected
Message on the display: Engine RPM — Not detected
Code 95-13 occurs in machines: Genie S-40 XC.
blocking fault
The Genie display shows code 95-13 with the message “Engine RPM — Not detected”. It is a blocking fault or a safety-related code: do not use the machine until the cause has been found and removed.
Effect on the machine: Engine start disabled.
Possible causes
- Control system has detected no or too low RPM.
What you can do
Switch the machine off with the emergency stop and switch it on again. If the code comes back, do not use the machine and call service.
Solution from the manual
* Verify wiring at the alternator. * Check tach signal at alternator while trying to start the engine. * Replace alternator.
Source: Genie Service and Repair Manual S-40 XC (Part No. 1322629, 1286829GT), Fault Codes section.
The descriptions are quoted from the manufacturer's service documentation and are for guidance only. Clearing codes, calibrations and repairs are carried out by a qualified service technician according to the manual for the specific serial number. A machine with an active blocking code must not be used until the cause has been removed.
Does code 95-13 not go away?
RK Rental services Genie lifts at our workshop or on site at the customer's premises (construction site, factory, warehouse). We read the code, remove the cause and select the parts by serial number.
Genie service · Genie parts · All Genie codes of this system