Genie S-85 XC FE and S-85 XC E (hybrid and electric drive)
Genie error code 20-16 — Primary boom extend/retract joystick — Value at 0 V
Message on the display: Primary boom extend/retract joystick — Value at 0 V
Code 20-16 occurs in machines: Genie S-85 XC FE, S-85 XC E.
blocking fault
The Genie display shows code 20-16 with the message “Primary boom extend/retract joystick — Value at 0 V”. It is a blocking fault or a safety-related code: do not use the machine until the cause has been found and removed.
Effect on the machine: Associated function disabled
Possible causes
- 0V at neutral
What you can do
Switch the machine off with the emergency stop and switch it on again. If the code comes back, do not use the machine and call service.
Solution from the manual
(P110RET BK). * Output of 1.5-3.5V across range of motion
Source: Genie Service and Repair Manual S-85 XC FE / E (Part No. 1337498), Fault Codes section.
The descriptions are quoted from the manufacturer's service documentation and are for guidance only. Clearing codes, calibrations and repairs are carried out by a qualified service technician according to the manual for the specific serial number. A machine with an active blocking code must not be used until the cause has been removed.
Does code 20-16 not go away?
RK Rental services Genie lifts at our workshop or on site at the customer's premises (construction site, factory, warehouse). We read the code, remove the cause and select the parts by serial number.
Genie service · Genie parts · All Genie codes of this system
Neighbouring Genie codes
- 18-26Proportional relief 1 coil — Resistance too low
- 19-27Auxiliary enable toggle switch — Active at startup
- 20-11Primary boom extend/retract joystick — Shorted to supply
- 20-17Primary boom extend/retract joystick — Not calibrated
- 21-11Pri Boom Up / Down Joystick — Shorted to supply
- 21-16Pri Boom Up / Down Joystick — Value at 0 V