Genie S-85 XC FE and S-85 XC E (hybrid and electric drive)
Genie error code 72-14 — Lift guard contact alarm switch — Cross check fault
Message on the display: Lift guard contact alarm switch — Cross check fault
Code 72-14 occurs in machines: Genie S-85 XC FE, S-85 XC E.
blocking fault
The Genie display shows code 72-14 with the message “Lift guard contact alarm switch — Cross check fault”. It is a blocking fault or a safety-related code: do not use the machine until the cause has been found and removed.
Effect on the machine: Lift and Drive functions disabled
Possible causes
- NO/NC contacts not connected correctly or welded shut
What you can do
Switch the machine off with the emergency stop and switch it on again. If the code comes back, do not use the machine and call service.
Solution from the manual
* Verify with proximity switch connected: 0V on N.O. proximity switch output and at VCON pin J13-9 (C247CTA OR/BK). 26V on N.C. proximity switch output and at PCON pin J11-11 (C248CTA OR/RD). * With proximity switch disconnected: Voltages are reversed.
Source: Genie Service and Repair Manual S-85 XC FE / E (Part No. 1337498), Fault Codes section.
The descriptions are quoted from the manufacturer's service documentation and are for guidance only. Clearing codes, calibrations and repairs are carried out by a qualified service technician according to the manual for the specific serial number. A machine with an active blocking code must not be used until the cause has been removed.
Does code 72-14 not go away?
RK Rental services Genie lifts at our workshop or on site at the customer's premises (construction site, factory, warehouse). We read the code, remove the cause and select the parts by serial number.
Genie service · Genie parts · All Genie codes of this system