Genie S-85 XC FE and S-85 XC E (hybrid and electric drive)
Genie error code 84-14 — Chassis angle (Primary) — Cross check fault
Message on the display: Chassis angle (Primary) — Cross check fault
Code 84-14 occurs in machines: Genie S-85 XC FE, S-85 XC E.
blocking fault
The Genie display shows code 84-14 with the message “Chassis angle (Primary) — Cross check fault”. It is a blocking fault or a safety-related code: do not use the machine until the cause has been found and removed.
Effect on the machine: Limited to 2 MPH. Elevated Drive disabled. Boom not allowed to leave stowed position. Tilt alarm on.
Possible causes
- Crosscheck between operational and safety channels failed
What you can do
Switch the machine off with the emergency stop and switch it on again. If the code comes back, do not use the machine and call service.
Solution from the manual
* Check level sensor installation. * Perform calibration procedure * Replace level sensor.
Source: Genie Service and Repair Manual S-85 XC FE / E (Part No. 1337498), Fault Codes section.
The descriptions are quoted from the manufacturer's service documentation and are for guidance only. Clearing codes, calibrations and repairs are carried out by a qualified service technician according to the manual for the specific serial number. A machine with an active blocking code must not be used until the cause has been removed.
Does code 84-14 not go away?
RK Rental services Genie lifts at our workshop or on site at the customer's premises (construction site, factory, warehouse). We read the code, remove the cause and select the parts by serial number.
Genie service · Genie parts · All Genie codes of this system