609 609 105609 609 104

Genie S-85 XC FE/E, S-60 DC, Z-60 DC: drive motor controllers

Genie error code 0x2133 — Speed Limit Supervision

Message on the display: Speed Limit Supervision

Code 0x2133 occurs in machines: Genie S-85 XC FE, S-85 XC E, Z-60 DC, S-60 DC.

blocking fault

Flash pattern 1-9 (flash code 0x19).

Description from the Genie service manual, in the original wording.

Effect on the machine: ShutdownInterlock ShutdownEMBrake

Possible causes

  • Motor speed detected that exceeds the limit set by the Max Speed Supervision parameter.
  • Misadjusted Max Speed Supervision parameters. See: Programmer » Application Setup » Max Speed Supervision menu.

What you can do

Switch the machine off with the emergency stop and switch it on again. If the code comes back, do not use the machine and call service.

Solution from the manual

Set: Motor rpm has exceeded the Max Speed Limit setting for the Max Speed Time Limit setting’s duration. Clear:Reset Controller.

Source: Genie Service and Repair Manuals (Part No. 1337498, 1307785, 1299608), drive controller code table.

The descriptions are quoted from the manufacturer's service documentation and are for guidance only. Clearing codes, calibrations and repairs are carried out by a qualified service technician according to the manual for the specific serial number. A machine with an active blocking code must not be used until the cause has been removed.

Does code 0x2133 not go away?

RK Rental services Genie lifts at our workshop or on site at the customer's premises (construction site, factory, warehouse). We read the code, remove the cause and select the parts by serial number.

Book a service

Genie service · Genie parts · All Genie codes of this system

Neighbouring Genie codes