Genie S-85 XC FE and S-85 XC E (hybrid and electric drive)
Genie error code 200-21 — RF Speed Sensor — Fault
Message on the display: RF Speed Sensor — Fault
Code 200-21 occurs in machines: Genie S-85 XC FE, S-85 XC E.
blocking fault
The Genie display shows code 200-21 with the message “RF Speed Sensor — Fault”. It is a blocking fault or a safety-related code: do not use the machine until the cause has been found and removed.
Effect on the machine: Reduced Speed Drive, Wheel affected locked -or- EM brake set. Main Contactor Open. No Drive of failed motor. Reduces machine drive speed.
Possible causes
- Motor Sin/Cos Encoder feedback signal fault Stalled motor. Motor encoder failure. Bad crimps or faulty wiring. Problems with power supply for the motor encoder.
What you can do
Switch the machine off with the emergency stop and switch it on again. If the code comes back, do not use the machine and call service.
Solution from the manual
Check Motor Encoder (Sin/Cos) & Wiring. (D185SEN WH, D186SEN BL, P109PWR and P110RET BK)
Source: Genie Service and Repair Manual S-85 XC FE / E (Part No. 1337498), Fault Codes section.
The descriptions are quoted from the manufacturer's service documentation and are for guidance only. Clearing codes, calibrations and repairs are carried out by a qualified service technician according to the manual for the specific serial number. A machine with an active blocking code must not be used until the cause has been removed.
Does code 200-21 not go away?
RK Rental services Genie lifts at our workshop or on site at the customer's premises (construction site, factory, warehouse). We read the code, remove the cause and select the parts by serial number.
Genie service · Genie parts · All Genie codes of this system