Genie S-85 XC FE/E, S-60 DC, Z-60 DC: drive motor controllers
Genie error code 0x2880 — PWM DRIVER COUNT
Message on the display: PWM DRIVER COUNT
Code 0x2880 occurs in machines: Genie S-60 DC.
blocking fault
Flash pattern 12-4.
Description from the Genie service manual, in the original wording.
Effect on the machine: 1. Home switch disconnected, or broken 2. Check wiring to ensure both switches have continuity to controller connector 3. Check if configured correctly for NC/NO
Possible causes
- PWM Driver Count Too many drivers configured for full PWM control range
What you can do
Switch the machine off with the emergency stop and switch it on again. If the code comes back, do not use the machine and call service.
What service does
A qualified service technician reads the code with the manufacturer's diagnostic tools, finds the cause, clears the code and carries out a function test.
Source: Genie Service and Repair Manuals (Part No. 1337498, 1307785, 1299608), drive controller code table.
The descriptions are quoted from the manufacturer's service documentation and are for guidance only. Clearing codes, calibrations and repairs are carried out by a qualified service technician according to the manual for the specific serial number. A machine with an active blocking code must not be used until the cause has been removed.
Does code 0x2880 not go away?
RK Rental services Genie lifts at our workshop or on site at the customer's premises (construction site, factory, warehouse). We read the code, remove the cause and select the parts by serial number.
Genie service · Genie parts · All Genie codes of this system