Genie S-85 XC FE/E, S-60 DC, Z-60 DC: drive motor controllers
Genie error code 0x2150 — Motor Temp Sensor
Message on the display: Motor Temp Sensor
Code 0x2150 occurs in machines: Genie S-85 XC FE, S-85 XC E, Z-60 DC, S-60 DC.
warning / function limited
Flash pattern 2-9 (flash code 0x29).
Description from the Genie service manual, in the original wording.
Effect on the machine: Motor temperature cutback disabled. Fault Action: None, unless a fault action is programmed in VCL.
Possible causes
- Motor thermistor is not connected properly.
- Sensor polarity (between Pin 8 and Pin 18) is incorrect.
- The motor temperature and sensor parameters are misadjusted. See Programmer » System Monitor menu » AC Motor» Temperature.
What you can do
Switch the machine off with the emergency stop and switch it on again. If the code comes back, do not use the machine and call service.
Solution from the manual
Set: Motor thermistor input (pin 9) is at the voltage rail. Clear: Bring the motor thermistor input voltage within range.
Source: Genie Service and Repair Manuals (Part No. 1337498, 1307785, 1299608), drive controller code table.
The descriptions are quoted from the manufacturer's service documentation and are for guidance only. Clearing codes, calibrations and repairs are carried out by a qualified service technician according to the manual for the specific serial number. A machine with an active blocking code must not be used until the cause has been removed.
Does code 0x2150 not go away?
RK Rental services Genie lifts at our workshop or on site at the customer's premises (construction site, factory, warehouse). We read the code, remove the cause and select the parts by serial number.
Genie service · Genie parts · All Genie codes of this system
Neighbouring Genie codes
- 0x2531Ext 5V Supply Failure Ext 5V Supply Failure Active _ _ _ _ 0x2531 Fault Type(s):
- 0x2532Ext 12V Supply Failure Fault Type(s):
- 0x2151Motor Temp Hot Cutback
- 0x2222Main Driver Fault Type(s):
- 0x2320EM Brake Driver Fault Type(s):
- 0x2232Sin Cos Motor Feedback 1. The signals from the sensor are above the configuration by 10% or at/above the supply rails for >100ms. 2. Sensor failure.