Genie XC, HF and J boom lifts (S-60 XC, S-80 XC, S-85 XC, S-80 HF, S-85 HF, S-60 J, S-80 J)
Genie error code 98-13 — Platform Level Angle — Not detected
Message on the display: Platform Level Angle — Not detected
Code 98-13 occurs in machines: Genie S-80 XC, S-85 XC, S-80 HF, S-85 HF.
blocking fault
The Genie display shows code 98-13 with the message “Platform Level Angle — Not detected”. It is a blocking fault or a safety-related code: do not use the machine until the cause has been found and removed.
Effect on the machine: Boom Up, Extend and/or Drive and Steer will not operate.
Possible causes
- No CAN messages have been received by the TCON from the angle sensor.
What you can do
Switch the machine off with the emergency stop and switch it on again. If the code comes back, do not use the machine and call service.
Solution from the manual
* Calibrate boom angle sensor. * Calibrate platform level angle sensor. * Verify sensor power P26PWR (BK, PCON J13-9) is at 12V while the system is running. * Verify the sensor is receiving power. Unplug the platform level angle sensor and verify 12 V across pins 2 (+) and 1 (-) on the harness connector. * Verify the CAN bus wiring. With the sensor still unplugged, measure resistance across harness connector pins 3 and 4. If resistance is not between 55 and 65 ohms, check CAN wire harnesses. * Replace platform angle sensor.
Source: Genie Service and Repair Manuals (Part No. 1316494, 1315679, 1288652, 1280490, 1285305, 1285307), Fault Codes section.
The descriptions are quoted from the manufacturer's service documentation and are for guidance only. Clearing codes, calibrations and repairs are carried out by a qualified service technician according to the manual for the specific serial number. A machine with an active blocking code must not be used until the cause has been removed.
Does code 98-13 not go away?
RK Rental services Genie lifts at our workshop or on site at the customer's premises (construction site, factory, warehouse). We read the code, remove the cause and select the parts by serial number.
Genie service · Genie parts · All Genie codes of this system